EFIDynoTuning Forum

I have tried everything I can think of... cranks but won't start, no injector pulse. swapped ecu to a WSX2 with RZASA with the PATS patch applied burned to a Moates chip with no luck. Anyone have experience with this setup?

sounds like your either missing the crank sensor input or the injector voltage feed.

What does tunerpro show on the dash while cranking? You should see rpms as its turning over.

I have power at the injectors, didn't check crank rpm with TunerPro but OBDLink with bluetooth adapter shows crank rpm

Then you have some issues.

got it, must have a corrupt burn, reprogrammed again and everything is good

one more thing, i don't see where to change cooling fan on/off temperature setting

also, what would cause the trans to ship super fast? like 1 to 4 in 50yards

check your oss teeth count and make sure your speedo is accurate

ok, oss was 12 changed to 24. found the fan temp settings... one more question, gear ratio settings. factory would have been 3.27, it has a 3.73 now

simple change it

be sure to set the vid speedo switch to 0 so it uses the cal values