EFIDynoTuning Forum

Hi, what is the purpose of having both FN513 and the THBP2 scalar, other than FN513 being capable of RPM scaling? Does either take precedence over the other if set to a lower value?

Is it preferred to set both the same or in some offset fasion?

there is none

fn513 is the updated code for thbp2

that scalar might just be a place holder there

fn513 is what you want

Perfect! Thanks

THBP2 does not exist in the CBAZ* strategies.

Thanks Sailorbob. The knowledge you all have about these things is a huge help. It's a little confusing when a parameter is left hanging out there like that particular one. I found no mention of THBP2 in the CBAZA document, yet here the scalar is, LOL

if u have the cbaza doc please do send it to me that would be a big help

PM sent

Me too, please. PM sent.

DOHCTOR_32V wrote: ↑2022 May 27, 15:26PM sent

can you send that to me too please? I've never been able to find it.

If you have a CBAZ* definition with THBP2 in it then the definition is wrong. If you post the address of the parameter I'll see what it actually is (assuming I have figured it out in my disassembly!).