Cooke, Brian (68 Bronco)

Place for your vehicle notes and blow-by-blow build threads.
nvrstuk
Posts: 73
Joined: 2022 Feb 02, 23:15
Location: Ellensburg, WA
Vehicle Information: '68 Ford Bronco
A9l, Moates Qtrhorse
460sbf, 92 octane 6r80 trans, ProCase 3:1 transfer case, 40" tires, 5.13:1 frt/rear gear ratios, Air lockers, 5350#'s.
WOT only - 92uego

Re: Cooke, Brian (68 Bronco)

Unread post by nvrstuk »

Michael-

Did a data log tonight.

New wires with resistance checked, new Motorcraft plugs gapped at .050".

You probably don't remember but we had a "bog" or hesitation of some kind around 4K or so last time and couldn't figure it out Anyway, it's much worse now.

You'll see it in the datalog.

I can send you a pic of my air intake if you think you want to see that.

Whatever you need but it's a very noticeable "lack of power" in the rpm band then it takes off fine and accelerates like a bandit to redline just like it does from idle to this rpm band.

Brian
Attachments
Datalog #5 7-16-23.xdl
(702.24 KiB) Downloaded 9 times
nvrstuk
Posts: 73
Joined: 2022 Feb 02, 23:15
Location: Ellensburg, WA
Vehicle Information: '68 Ford Bronco
A9l, Moates Qtrhorse
460sbf, 92 octane 6r80 trans, ProCase 3:1 transfer case, 40" tires, 5.13:1 frt/rear gear ratios, Air lockers, 5350#'s.
WOT only - 92uego

Re: Cooke, Brian (68 Bronco)

Unread post by nvrstuk »

Correct, didn't touch the fuel
nvrstuk
Posts: 73
Joined: 2022 Feb 02, 23:15
Location: Ellensburg, WA
Vehicle Information: '68 Ford Bronco
A9l, Moates Qtrhorse
460sbf, 92 octane 6r80 trans, ProCase 3:1 transfer case, 40" tires, 5.13:1 frt/rear gear ratios, Air lockers, 5350#'s.
WOT only - 92uego

Re: Cooke, Brian (68 Bronco)

Unread post by nvrstuk »

Put another 40 miles on it today. Runs good till I hit the pedal hard. I watched the AFR carefully and at appr 4200rpms it bogs and the wide band reads over 15.2:1. Seemed to do it once, catch itself and then do it again above 4500rpm. Fugly!

I know nothing about tuning this system but it sure seems that lack of fuel could be causing that "bog" or whatever you want to call it. I don't notice it as much when it's not under a real load when doing a quick 2 sec burnout on my bridge tonight.
nvrstuk
Posts: 73
Joined: 2022 Feb 02, 23:15
Location: Ellensburg, WA
Vehicle Information: '68 Ford Bronco
A9l, Moates Qtrhorse
460sbf, 92 octane 6r80 trans, ProCase 3:1 transfer case, 40" tires, 5.13:1 frt/rear gear ratios, Air lockers, 5350#'s.
WOT only - 92uego

Re: Cooke, Brian (68 Bronco)

Unread post by nvrstuk »

Are you able to see the bog in the datalog I sent?
nvrstuk
Posts: 73
Joined: 2022 Feb 02, 23:15
Location: Ellensburg, WA
Vehicle Information: '68 Ford Bronco
A9l, Moates Qtrhorse
460sbf, 92 octane 6r80 trans, ProCase 3:1 transfer case, 40" tires, 5.13:1 frt/rear gear ratios, Air lockers, 5350#'s.
WOT only - 92uego

Re: Cooke, Brian (68 Bronco)

Unread post by nvrstuk »

I ran a fuel pressure check and it stayed at the (on my gauge) 38-39#'s up thru 5,000rpm.

I left you a couple more texts and a brief voice mail.
nvrstuk
Posts: 73
Joined: 2022 Feb 02, 23:15
Location: Ellensburg, WA
Vehicle Information: '68 Ford Bronco
A9l, Moates Qtrhorse
460sbf, 92 octane 6r80 trans, ProCase 3:1 transfer case, 40" tires, 5.13:1 frt/rear gear ratios, Air lockers, 5350#'s.
WOT only - 92uego

Re: Cooke, Brian (68 Bronco)

Unread post by nvrstuk »

Another note-

2 different things going on???

1- When I pin to WOT I get the bog in 2nd gear for datalogs.

2- When I accelerate more gradually through that same rpm range I do not get any bog and my fuel psi gauge does not waver either time.

Just info- I have not touched my FP regulator and I had 6.5" of vacuum at idle with my old cam and I now have almost 9.5" at idle and I am at appr 38-39 psi when I turn the key on prior to starting.
nvrstuk
Posts: 73
Joined: 2022 Feb 02, 23:15
Location: Ellensburg, WA
Vehicle Information: '68 Ford Bronco
A9l, Moates Qtrhorse
460sbf, 92 octane 6r80 trans, ProCase 3:1 transfer case, 40" tires, 5.13:1 frt/rear gear ratios, Air lockers, 5350#'s.
WOT only - 92uego

Re: Cooke, Brian (68 Bronco)

Unread post by nvrstuk »

I sent a long text today, Wed, 7-30-23. Please read it.
decipha
Posts: 5052
Joined: 2021 Feb 15, 12:23
Location: Metairie, LA
Vehicle Information: Work Truck
'19 F-150 3.3L

Re: Cooke, Brian (68 Bronco)

Unread post by decipha »

Very nice looks like 92uego is what the wideband matches at WOT from what you said about the 15.2 afr and what the narrowband showed as well.

She looks excellent just the maf needed some corrections up top where you couldn't reach before.

This should make her significantly happier.
Attachments
BCOO_220203F8b_MAF.bin
(56 KiB) Downloaded 10 times
Post Reply