Page 1 of 1

Datalogging corrupting tune

Posted: 2023 Nov 18, 18:41
by D3fault
I’m using a moates quarterhorse with a crai8 strategy ecu and every time I select “aquire data” to try and data log my car it corrupts my tune and the gauges and numbers spaz out and read erratically. Reflash my tune and alls fine until I try to data log it again. I’m using deciphas crai8 ADX file. Do I have a hardware issue or is something in tunerpro not configured correctly? I can read write and live tune the car perfectly fine I just can’t log it without it stalling and erasing my file. Any help is appreciated. I read the getting started guide but couldn’t find the “universal adx file” that’s mentioned and thought the strategy specific one would suffice.

Re: Datalogging corrupting tune

Posted: 2023 Nov 19, 10:01
by decipha
soubds like your adx file is screwed

what version are you using?

Re: Datalogging corrupting tune

Posted: 2023 Nov 19, 17:15
by D3fault
The latest one that’s on the crai8 strategy file post. Do you have another I could try? I was never able to find the universal adx mentioned in the beginner guide.

Re: Datalogging corrupting tune

Posted: 2023 Nov 20, 10:53
by decipha
They are all univ adx as I only maintain 1 for all strategies.

Attached the current. Give it a go.

Re: Datalogging corrupting tune

Posted: 2023 Nov 21, 14:06
by D3fault
that seems to have done the trick. much appreciated. i did notice some values read slightly higher than expected. example my idle is set for 750 but it reads closer to 900 on the tunerpro dash and my coolant temp reads a good 10 or so degrees higher than my mechanical gauge. is there a calibration process i need to perform or is some variance just is what it is?

Re: Datalogging corrupting tune

Posted: 2023 Nov 21, 14:18
by decipha
no calibration and no variance

what the log tells you is what you have