Datalogging / Standardized ADX

by Michael Decipha Ponthieux
Posted: 1-31-2017
Last Updated: 2018-11-13

For SCT Datalogging CLICK HERE

Patching the datalogging code

There are 10 simple steps you must do in order to datalog.
1-first, you must download your strategy specific adx from the homepage under the downloads section.
2-second, you must download the strategy you'll be using from the homepage as well from the downloads section.
3-third, unzip the adx and xdf and double click them to load them into TunerPro.
4-fourth, load your current .bin tune file into tunerpro and hold the Ctrl button on the keyboard and press F to bring up FIND
5-fifth, type in: datalogging and press enter. Double click on the Enable Datalogging Patch and PATCH your tune file.
Note: If you downloaded a base tune the datalogging patch code may already be patched, in that case the PATCH button will be greyed out since its already enabled.
6-sixth, SAVE your modified tune and then WRITE it to the QH.

THE ABOVE IS ONLY DONE ONCE, AFTER YOU HAVE PATCHED YOUR BIN YOU WILL NEVER HAVE TO DO THE ABOVE EVER AGAIN OTHER THAN TO UPDATE TO NEWER PATCH CODE WHEN ITS RELEASED IF YOU SO DESIRE.
Now keep in mind this is only done once to patch your tune. Once your tune is patched you will never have to patch it again so long as you don't remove the patch by using the disable datalogging patch.
Polling Data
7-seven, click up top on the two blue arrows to begin polling data from the QH
8-eighth, click the red dash icon to bring up the dashboard to view the parameters in realtime
You can poll data indefinitely it does not use up hard drive space and just streams the realtime data from the QH to be viewed in realtime ONLY.
Saving a datalog
9ninth- click on the red dot to the far right next to the playback buttons (fordward, reverse, pause, stop) to begin recording a log.
10lastly- click on the stop button to stop the log after you have the data you want. TunerPro will then ask you where you want to save it.


So the next time you open up tunerpro and go to datalog you only do steps 7 through 10.

The images below are outdated but the priciple remains the same.






-Enjoy.
To inquire about adding datalogging support for other strategies post a thread.

If you are a progammer inquiring about implementing datalogging yourself on your own strategy check out the Disassembly Write Up for technical details.


Return Home
Jump to Forum
www.EFIDynoTuning.com - EFIDynoTuning LC - New Orleans, LA